Drive System Europe V Linear Actuator, 300mm Stroke, 200N, 90mm/s, DSAK4-12-200-300-IP54 DSAK4-12-200-300-IP54 数据表
产品代码
DSAK4-12-200-300-IP54
© Copyright by Drive-System Europe Ltd.
Stand: 14.11.2012
Installation manual DSAK4
Make sure the actuator ist not connected electrically when installed.
Make sure you use the correct DC voltage.
Actuator force must not be over loaded. Please refer to the model
number and it’s force specification.
To avoid over load disconnect the actuator if the current exceed
it’s maximum rating.
The load should be centered on the operating direction. Side load
is NOT good for the actuator.
In case the actuator rod is exposed to side load the service life
time will be reduced.
Make sure you use the correct DC voltage.
Actuator force must not be over loaded. Please refer to the model
number and it’s force specification.
To avoid over load disconnect the actuator if the current exceed
it’s maximum rating.
The load should be centered on the operating direction. Side load
is NOT good for the actuator.
In case the actuator rod is exposed to side load the service life
time will be reduced.
Speed- and current-diagram
Load– Current – diagram
Load – Speed - diagram
In order to retract or extract again the supply voltage
polarity must be reverted.
The actuator have integrated limit switches that will stop the
rod when it reach it’s end position of extraction or
retraction.
polarity must be reverted.
The actuator have integrated limit switches that will stop the
rod when it reach it’s end position of extraction or
retraction.
Attention
Will become the cylinder in the not built-in state without any load driven, can do it potentially to running noise come.
This is design related and no function failure.
Drive-System Europe Ltd.