Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 数据表
产品代码
6ED1057-3BA00-0AA8
User interface
2.8 Menu bar
LOGO!Soft Comfort Online Help
66
Operating Instructions, 06/2014
2.8.3.3
Format -> Format grid
This tool helps you to organize the various objects of your circuit program on the
programming interface. The grid is visible by default.
You can adjust the grid pattern (spacing) in increments of 5 points.
If you have enabled the "Snap Block to Grid" function, LOGO!Soft Comfort aligns the objects
You can adjust the grid pattern (spacing) in increments of 5 points.
If you have enabled the "Snap Block to Grid" function, LOGO!Soft Comfort aligns the objects
with the relevant grid intersections. This helps you to avoid a vertical or horizontal offset of
the objects. To finely position objects on your programming interface, disable the "Snap
Block to Grid" function.
If you have enabled the "Snap Connection to Grid" function, LOGO!Soft Comfort aligns the
If you have enabled the "Snap Connection to Grid" function, LOGO!Soft Comfort aligns the
connection lines between objects with the relevant grid intersections. To allow connection
lines to stay unaligned with grid lines on the programming interface, disable the "Snap
Connection to Grid" function.
You can hide the grid with the Visibility check box.
You can select the "Use as Default" check box to keep your settings as the default for
You can hide the grid with the Visibility check box.
You can select the "Use as Default" check box to keep your settings as the default for
LOGO!Soft Comfort circuit programs.
2.8.3.4
Format -> Snap to grid
If you have made changes to the grid pattern, or inserted objects while you disable the grid,
the position of objects may be offset when you align them to the grid points. Use this
command to correct the offset of selected objects and to realign them.
2.8.4
View menu
From the View menu, you can choose the current working mode, decide to show or hide
various toolbars and trees under each mode, and set the zoom factor for the display of your
circuit diagram or network project. The View menu contains the following commands.
● Diagram Mode (Page 67)
● Project Mode (Page 67)
● Toolbars (Page 67)
● Tree
● Diagram Mode (Page 67)
● Project Mode (Page 67)
● Toolbars (Page 67)
● Tree