Siemens SPS starter kit 6ED1057-3BA10-0AA8 6ED1057-3BA10-0AA8 数据表
产品代码
6ED1057-3BA10-0AA8
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 06/2014, A5E33039675
Manual, 06/2014, A5E33039675
67
The first line is highlighted. Press and to move the highlight bar up and down. Move it to
"
①
" and confirm with OK. LOGO! opens the programming menu.
The LOGO!'s programming menu is as shown below:
Here you can also move the highlight bar by pressing and . Move the highlight bar to "
②
"
and confirm with OK.
You are now in the circuit program window. Press OK to enter the program editing mode,
You are now in the circuit program window. Press OK to enter the program editing mode,
and the cursor appears as a solid square at the "NEW" block. The display now shows as
follows:
Confirm with OK and LOGO! now shows you the first output:
You are now in programming mode. Press and to select the other outputs. Now you can
start to edit your circuit program.
Note
Because you have not yet saved a password for the circuit program in LOGO!, you can
Because you have not yet saved a password for the circuit program in LOGO!, you can
directly enter editing mode. When you select to edit the program after you have saved a
password-protected circuit program, LOGO! prompts you to enter a password and to confirm
it with OK. You can only edit the program after you have entered the correct password
(Page 74).
If you have created your circuit program in LOGO!, you can view it in the circuit program
If you have created your circuit program in LOGO!, you can view it in the circuit program
window by moving cursor on the blocks. LOGO! can display a maximum of 31*31 blocks in
the circuit program window.
3.7.2
The first circuit program
The following parallel circuit consists of two switches.