Auerswald COMfortel 2600 90117 用户手册
产品代码
90117
Commissioning
COMfortel 1600/2600 - Firmware Version 1.0 - Commissioning Instructions 01 08/12
47
This section describes how to commission the telephone and the answering machine on the
COMfortel 2600 for the first time in a stepwise procedure. After a successful initial
commissioning, you will be able to make calls. You can customize your telephone and the
answering machine using the PC configuration described at the end of this section.
COMfortel 2600 for the first time in a stepwise procedure. After a successful initial
commissioning, you will be able to make calls. You can customize your telephone and the
answering machine using the PC configuration described at the end of this section.
Commissioning the Telephone
Requirements
–
PBX, switched on (connected to 230 V mains)
–
The internal telephone number for the telephone entered in the
configuration (COMset) on the internal S
configuration (COMset) on the internal S
0
or U
P0
port on the PBX
Note: Only connect one ISDN device for each internal subscriber
telephone number to your PBX.
telephone number to your PBX.
–
For the operation with COMfortel Xtension300 key extension modules: the
wall-mounted power supply type No. FW7577/EU/40
wall-mounted power supply type No. FW7577/EU/40
–
For the operation without COMfortel Xtension300 key extension modules:
The bridge plug is inserted into the jack marked with
The bridge plug is inserted into the jack marked with
at the lower side
of the telephone
–
The PBX with at least the following firmware version:
COMpact 3000: 4.2A
COMpact 5010 VoIP, COMpact 5020 VoIP, COMmander Basic.2 and
COMmander Business: 4.2A
COMmander Business: 4.2A
COMmander 6000/R/RX: 5.4B
Note: If you have devices with older firmware versions, carry out the
corresponding device updates (see PBX manual).
corresponding device updates (see PBX manual).
Steps to Take
1.
Insert the plug of the ISDN cable included in the package into the jack
marked with
marked with
2.
Insert the other ISDN cable plug into the ISDN socket connected to the
PBX.
PBX.
3.
If required, insert the wall-mounted power supply type no. FW7577/EU/40
into a freely-accessible 230 V mains socket.
into a freely-accessible 230 V mains socket.
The telephone starts up. In the meantime, the Auerswald company icon
is shown on the display.
is shown on the display.
Commissioning