Datalogic PowerScan PD9500 PD9530-HPK1 数据表
产品代码
PD9530-HPK1
Enter/Exit Programming Mode
232
PowerScan™ PD9530/PBT9500/PM9500
Bluetooth Friendly Name
You can set a meaningful name for PowerScan BT9500 that will appear in the
application during device discovery.
To set a new Bluetooth Friendly Name, scan the barcode below and follow
To set a new Bluetooth Friendly Name, scan the barcode below and follow
the instructions.
Bluetooth Reconnect Attempt Mode
Enable/Disable reconnection by trigger pull.
$CBTRM00(CR)
Bluetooth Reconnect Attempt Mode = Disable
$CBTRM01(
Bluetooth Reconnect Attempt Mode = Enable
DEFAULT
Set Bluetooth Friendly Name
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by a maximum 64 digits from the
Alphanumeric characters in
GRAMMING MODE bar code above, then the bar code
at left followed by a maximum 64 digits from the
Alphanumeric characters in
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the expected
string of 32 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
tion of the desired characters. If less than the expected
string of 32 characters are selected, scan the ENTER/
EXIT bar code to terminate the string.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
and not save the entry string. You can then start again
at the beginning.
CANCEL
$CBTFN
~
DEFAULT
POWERSCAN BT9500
[SERIAL_NUMBER_SCANNER]
[SERIAL_NUMBER_SCANNER]