Datalogic PowerScan PD9500 PD9530-HPK1 数据表

Setup

18

PowerScan™ PD9530/PBT9500/PM9500

If you aren’t sure what programming options are in your imager, or you’ve 

changed some options and want to restore the Custom Default Configura-

tion that may have been saved in the scanner, scan the Restore Custom 

Default Configuration bar code below. This will restore the custom configu-

ration for the currently active interface. 

Restore Custom Default Configuration

$P,HA00,P(CR)

The "Restore Custom Default Configuration" command above is normally 

enough to restart the machine from a known status (set in the factory or by 

the customer via configuration file). The machine is set as it arrived to you 

from the factory or according to the custom configuration file you loaded 

afterward. 
If you want to 

permanently cancel

 the setup defined by the configuration 

file use 

 of this manual.

The programming items listed in the following sections show the factory 

default settings for each of the menu commands. If no configuration file has 

been loaded, the above command restores the factory default. 

1. Scan the Enter/Exit Programming bar code below to set date and time.

ENTER/EXIT PROGRAMMING MODE

2. Scan the Set Date bar code + six 

digits for Year, Month and Day 

.

Set Date

Set Time

3. Scan Set Time + six digits for 

Hours, Minutes and Seconds 

. 

4. Scan the Enter/Exit Programming bar code to complete.