Datalogic PowerScan PD9500 PD9530-HPK1 数据表

References

286

PowerScan™ PD9530/PBT9500/PM9500

Up to 20 ASCII characters may be added as a prefix (in a position before the 

bar code data) and/or as a suffix (in a position following the bar code data) 

as indicated in Figure 8.

Prefix

Suffix

AIM ID

Label ID

Label ID

Bar Code Data

00 - 20 Characters (ASCII)

OR...

In this example, we’ll set a prefix for all symbologies.

1. Determine which ASCII character(s) are to be added to scanned bar 

code data. In this example, we’ll add a dollar sign (‘$’) as a prefix. 

2. Go to 

 and scan the ENTER/EXIT PROGRAMMING MODE bar 

code, then scan the SET GLOBAL PREFIX bar code.

3. Reference the 

 on the inside back cover of this manual to 

find the hex value assigned to the desired character. The corresponding 

hex number for the ‘$’ character is 24. To enter this selection code, 

scan the ‘2’ and ‘4’ bar codes from 

.

4. If less than the expected string of 20 characters are selected, scan the 

ENTER/EXIT bar code to terminate the string.

5. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
6. The resulting message string would appear as follows: 

Scanned bar code data: 

 

Resulting message string output: 

AIM label identifiers (as opposed to custom characters you select yourself as 

with label identifiers) can be included with scanned bar code data. AIM label 

identifiers consist of three characters as follows:

• A close brace character (ASCII ‘]’), followed by...

• A code character (see the table below), followed by...