Datalogic PowerScan PD9500 PD9530-HPK1 数据表

Enter/Exit Programming Mode

Product Reference Guide

                           31

This parameter specifies the intercharacter delay between the end of one 

character and the beginning of the next. The delay can be set within a range 

of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-

fies no delay.
See 

 for more information.

$CR2IC00(CR)

Intercharacter Delay = No Delay

$CR2IC

Select Intercharacter Delay Setting

To configure this feature, scan the ENTER/EXIT 
PROGRAMMING MODE bar code above, then the bar 
code at left followed by the digits from the Alphanu-
meric characters in 

 repre-

senting your desired character(s). End by scanning 
the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort and 

not save the entry string. You can then start again at the 

beginning.

~

CANCEL

DEFAULT

When this parameter is enabled, the reader issues a beep when a <BEL> 

character is detected on the RS-232 serial line. <BEL> is issued to gain a 

user's attention to an illegal entry or other important event.

$CR2BB00(CR)

Beep On ASCII BEL = Disable

DEFAULT

$CR2BB01(CR)

Beep On ASCII BEL = Enable