Datalogic PowerScan PD9500 PD9530-HPK1 数据表

Enter/Exit Programming Mode

42

PowerScan™ PD9530/PBT9500/PM9500

Specifies amount of time to look for keyboard activity before scanner breaks 

keyboard connection in order to transmit data to host. The selectable range 

for this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments of 

ten milliseconds.

 

See 

 in “References” for detailed information and 

examples for setting this feature.

$CKBQI

Set Wedge Quiet Interval

To configure this feature, scan the ENTER/EXIT 
PROGRAMMING MODE bar code above, then 
the bar code at left followed by the digits from 
the Alphanumeric characters in 

 representing your desired character(s). 

End by scanning the ENTER/EXIT bar code 
again.

Make a mistake? Scan the CANCEL bar code to 
abort and not save the entry string. You can 
then start again at the beginning.

~

CANCEL

DEFAULT

 

Specifies the delay between labels transmitted to the host for this interface. 

The selectable range for this feature is from 0 to 99 seconds.
See 

 in “References” for detailed information and examples for set-

ting this feature.

$CKBID

Set Intercode Delay

To configure this feature, scan the ENTER/EXIT 
PROGRAMMING MODE bar code above, then 
the bar code at left followed by the digits from 
the Alphanumeric characters in 

 representing your desired character(s). 

End by scanning the ENTER/EXIT bar code 
again.

Make a mistake? Scan the CANCEL bar code to 
abort and not save the entry string. You can 
then start again at the beginning.

~

CANCEL

DEFAULT