ABUS Privest Wireless Alarm Base Set, DE FU9000 数据表

16 

When you activate the ABUS wireless alarm system, you activate, or arm, the sensors 
of the system (door and window contacts, glass breakage detectors, motion sensors, 
etc.). Every sensor is triggered by a particular event (a motion sensor by movement, a 
glass breakage sensor by glass breakage, a window contact by the opening of the 
secured window, a smoke detector by smoke, etc.). When the system is activated, the 
triggering of a sensor leads to an alarm. This chapter shows you the different ways of 
activating the ABUS wireless alarm system. If programmed, activation is confirmed by 
a local announcement.  
 
You can activate the system in two ways: 
- 

By entering your user PIN 

- 

By using the control buttons 

You can activate 3 different elements. You can: 
- activate 

externally 

(the complete system) 

- 

activate internally (detectors of the outer skin only) 

- activate 

partitions 

 

If you accidentally enter the wrong PIN during activation, the operating panel emits 3 brief 
tone signals. The display shows “Wrong Code. Please try again.” In this case, press 

 repeatedly and enter the correct PIN. 

 

 

Before activating the system, check the READY LED. If it is on or flashing, you can arm the 
system. If the READINESS LED is off or not flashing, your system is not ready and you 
cannot activate the ABUS wireless alarm system. In this case, you have to close or omit 
open zones. Then you can continue.