ABUS Privest Wireless Alarm Base Set, DE FU9000 数据表

24 

You can remote-operate the ABUS wireless alarm system using a pushbutton 
telephone. You can activate and deactivate your system, control switch outputs, record 
messages, and do many other things. To access your alarm system by telephone, 
enable the U/D function (Installer menu -> Dialer -> Controls). 

To operate the ABUS wireless alarm system by pushbutton telephone, you first have 
to call the system. Then enter your access code and your user PIN via the keypad, and 
you can operate your system from a distance. To be able to do this, you first have to 
enable the U/D function (Installer menu -> Dialer -> Controls). 
 
To access the system by telephone (remote access): 

1.  Dial the number of the building in which the alarm system is installed. 

Important: Use a pushbutton telephone! 

2.  Wait until the system answers your call. You hear a brief signal tone. Wait until 

this tone stops. 

3.  Enter your two-digit access PIN (default: 00). If you take longer than 10 

seconds doing this, the system starts with the U/D procedure. Then hang up, 
wait about 15 minutes and call again. 

4.  After entering your 2-digit access PIN, you hear the following message: “Hello. 

Please enter your user code, followed by [#] ”.  

5.  Follow this instruction: Enter your user PIN and press [#]. 
 

If you do not enter you access PIN within 10 seconds, the system starts with the U/D 
procedure. You have to call again. If you enter a bad PIN, you hear the message “Bitte 
geben Sie Ihren Benutzer PIN gefolgt von der [#] Taste ein”???.  
If you enter 3 invalid PINs, the system hangs up and is blocked for 15 minutes. During 
this period, all calls to the system are unanswered. However, event calls by the system 
can be received. 

 
6.  If your user PIN is accepted, you reach the operation menu.  

If an answering machine is in operation, let it ring once, hang up and call again. In this 
case, enable Answering Machine Override in the installer menu.