Futaba RC console 40 MHz No. of channels: 6 1-F4044 数据表
产品代码
1-F4044
Order Number
40 MHz No. F4044
FC-16 Boat `n Truck
12
14. SYSTEM ADJUSTMENTS (PARA)
14.1 SUBMENU MODULATION TYPE (PULS)
This function is used to select the chosen modulation, PCM-1024
or PPM. When using an FM Rx, then PPM must be selected, a
PCM Rx will use PCM mode (PCM will need the appropriate PCM
1024 Rx).
Selecting the “PARA” menu by pres-
sing the right cursor key twice to select
“PULS” menu. Press “+ or –“ keys for
at least 1 second to change the modu-
lation type.
It is important to understand that the
new modulation will not become active
until the Tx is turned off and on again.
You must check that the modulation
required is shown correctly in the dis-
play and that is now active.
14.2 SUBMENU MODEL MEMORY RESET (REST)
All model details in a memory may be deleted and reset to the
factory default condition. It is good practice, therefore before a
new model is programmed to delete the previous settings using
this function to reset to factory default condition.
The display will show.
Pressing both the “+ and –“ keys for 2 seconds, the reset process
will be initiated. The “CLR” will flash and then a beep will be heard
to show the reset process has been successfully completed.
Pressing “MODE” key will return to main menu.
NOTE: Resetting a model memory will delete all adjustments
back to factory default, There is no recovery of this data, so ple-
ase be careful how and when you use the REST function.
14.3 SUBMENU STICK MODE (STCK)
This menu allows you to choose the
stick control layout to suit you. The
stick controls 1-4 must always remain
in their factory position in the Tx con-
trols sockets for this software to func-
tion correctly.
• Select “STCK” function in “PARA” menu.
• Select “MODE” 1 to 4.
• The changes become active after turning Tx off and turning on
again.
MODE 1:
Steering right 1
Control 3
Throttle left 2
Control 4
MODE 2:
Steering right 1
Control 2
Throttle left 3
Control 4
MODE 3
Steering left 1
Control 3
Throttle left 2
Control 4
MODE 4
Steering left 1
Control 3
Throttle right 2
Control 4
15. MULTI-SWITCH (NAUT)
For marine and truck models which re-
quire many switched and proportional
controls. Using just two “normal” pro-
portional channels (7-8), it is possible
to cascade 2 x 16 switch, 2 x 12+2
multi or 2 x 8 proportional channels.
Using these modules, the FC16 then
can have 8 or 16 switch/proportional
channels. This can control up to 32 separate functions. To do this,
the Tx will need a Multi-Switch or Proportional module for every
8 channels required.
This module divides each proportional channel into 8 switch or
proportional channels. For 16 switched or proportional channels,
a second module is required.
• Using the “MODE” key, select NAUT function
• Using “CURSOR” key, select chosen channel (7 or 8)
• Press “+ or –“ keys to activate the selected channel
NOTE: The connection to the Tx PCB is described in chapter 26
“connection of option modules”
3
1
1
1
2
3
2
4
4
4
2
1
4
3
3
2