Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 用户手册

For simple programming of the system you have the option of copying data from one model memory to another. This 

helps to easily transfer basic settings and mixer between similar models and you only need to adjust the settings 

values to the new model.
Copying model data into another model memory:
•  Switch on the transmitter and call the system setting menu.
•  Move the cursor arrow to the menu item „Model copy“ with the

two buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The display shows two model memories with the respective 

activated model names and the associated model type figure.

The model memory above is the data source and the model 

memory below is the target memory. 

•  Use the buttons „UP“ or „DOWN“ to select the model memory

from which the data are to be copied. 

•  Briefly push the button „OK“ to switch to the target memory.
•  Use the buttons „UP“ or „DOWN“ to select the model memory

into which the data are to be copied. 

•  Push the button „OK“ for longer to start copying. The display

now shows a safety prompt.

•  Pushing the buttons „UP“ or „DOWN“ switches the cursor ar-

row from „No“ to „Yes“. Push the button „OK“ again to copy. 

The display then shows the system setup menu again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.

  Since the model name is also copied, call the model memory into which you copied the data right after 

copying and enter the name of the new model there at once. This avoids undesired mistakes among the 

model memories.