Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 用户手册

V-tail mixer (flight models only)

„V tail“

Gyro sensitivity setting (for helicopter models only)

„Gyroscope“

Switch assignment

„Switches assign“

Throttle switching

„Throttle hold“

  The menu items listed in the table are not all available in the function menu at the same time. Depending on 

the previously selected model type (helicopter or wing model), the menu items not needed or unsuitable for 

the required model are not displayed.

Depending on the position of the servos, a control movement to the left on the transmitter may invoke a steering mo-

vement to the right. This is why the transmitter allows you to individually set and save the rotting or running direction 

of every individual servo. 
Adjusting the servo running directions
•  Switch on the transmitter and call the function setting menu.

The top menu item „Reverse“ is marked by the cursor arrow.

•  Briefly push the button „OK“ to activate the menu item.
  In the display you will see display items for the six control func-

tions with the respective currently set running directions. „Nor“ 

corresponds to the standard running direction of the servo and 

„Rev“ to the reversed running direction.

•  Pushing the button „UP“ or „DOWN“ changes the rotating di-

rection of the servo at channel 1.

•  When pushing the button „OK“, the cursor arrow will jump to

channel 2.

•  Pushing the button „UP“ or „DOWN“ changes the rotating di-

rection of the servo at channel 2.

•  Briefly push the button „OK“ to switch to channel 3.
•  Repeat his process until you have set the correct running di-

rection of the servos in all six channels. 

•  Keep the button „CANCEL“ pushed for a longer period to save

the settings. The display then shows the function setup menu 

again.

•  Push the button „CANCEL“ repeatedly until you return to the

operating display and check if all servos have the correct run-

ning direction.