Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037 用户手册

In order to be able to practice an autorotation landing, you need to uncouple the motor function from the pitch stick 

using a toggle switch. The combustion engine must be at sufficient throttle so that the centrifugal clutch is reliably

open. Nevertheless, the motor should be set so that it spontaneously takes in gas and can be restarted immediately 

if the situation so requires.
The function can also be used as a safety switch. If the model is carried to the starting point after starting up the 

combustion engine, the throttle switch can be activated. Accidental adjustment of the throttle control stick then will not 

lead to undesired revving up of the engine. 
Setting the throttle switch:
•  Switch on the transmitter and call the function setting menu.
•  Move the cursor arrow to the menu item „Throttle hold“ with

the two buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The  display  shows  the  current  switching  condition  of  the 

throttle switch and the set value. The respective setting of the 

toggle switch for the throttle switch is also displayed at the 

lower edge of the display. The display „Not engaged“ shows 

that the throttle switch is deactivated. „Engaged“ means that 

the throttle switch is activated.

•  Pushing  the  buttons  „UP“  or  „DOWN“  can  activate  „On“  or

deactivate „Off“ the throttle switching.

•  When pushing the button „OK“, the cursor arrow will jump to

the setting value for throttle switching. 

•  Pushing  the  buttons  „UP“  or  „DOWN“  permits  setting  the

throttle servo with activated throttle switching so that the motor 

will securely run through in idle operation. If the button „OK“ is 

pushed and held, the factory parameters are called.

•  Keep the button „CANCEL“ pushed for a longer period to save

the settings. The display then shows the function setup menu 

again.

•  When pushing the toggle switch for throttle switching, the mo-

tor has to switch between the set idle speed and the speed 

corresponding to the current position of the control stick for the 

throttle function.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.