Renkforce 808577 用户手册
66
IR remote control does not work
• Remove the small transparent protective stripe from the battery compartment at initial commissioning;
• Remove the small transparent protective stripe from the battery compartment at initial commissioning;
pull it out completely.
• Replace the battery; observe correct polarity when inserting; see chapter 9 a).
• Align the small, transparent LED with the front of the IR remote control on the sensor at the front of the
• Align the small, transparent LED with the front of the IR remote control on the sensor at the front of the
screen/DVR. The range usually is several meters.
No playback of audio signals
• The two enclosed cameras do not have any integrated microphone.
If, whoever, other cameras of the same monitoring system (cameras with western plug) are connected
• The two enclosed cameras do not have any integrated microphone.
If, whoever, other cameras of the same monitoring system (cameras with western plug) are connected
to the screen/DVR and if these cameras have a microphone, the respective audio signal can be recorded
or played back as well.
Bad image quality of the recording
• Switch from the 320 x 240 pixels resolution to a higher one (640 x 480 or 720 x 576 Pixel), see chapter
• Switch from the 320 x 240 pixels resolution to a higher one (640 x 480 or 720 x 576 Pixel), see chapter
11 d), function „Rec Resolution“.
The recording is only black/white
• Due to the principle, the recording at night with the IR-LEDs activated will always be black/white and
• Due to the principle, the recording at night with the IR-LEDs activated will always be black/white and
never in colour.
The buttons on the screen/DVR or the IR remote control have no function
• While a recording is running, many functions will not work (e.g. calling the OSD menu).
• While a recording is running, many functions will not work (e.g. calling the OSD menu).