Renkforce Wireless Surveillance Kit808578 Resolution (TVL) 420 TVL 808578 数据表

Function „Motion Sensitivity“
In this function, the sensitivity of motion detection can be set in 3 hours. Selection of a lower sensitivity 

is recommended if there are, e.g., any trees and shrubbery in the monitored area the leaves of which are 

moving in the wind. 

  If error recordings happen often in spite of a lower sensitivity, the camera should be aligned 

differently or installed in a different site.

Proceed as follows:
•  Use the buttons „4“ and „6“ to choose the submenu „Motion Sensitivity“ and then push the button 

„PLAY/ENTER“ on the DVR or the button „

“ on the IR remote control.

•  Use the buttons „4“ and „6“ to switch between three sensitivity levels („Low“, „Medium“, „High“).
•  Confirm selection with the button „PLAY/ENTER“ on the DVR or the button „

“ on the IR remote cont-

rol.

•  Push the button „MENU/ESC“ on the DVR or the button „MENU“ on the IR remote control repeatedly to

return to the respective previous menu or leave the OSD menu.

Function „Schedule recording“
The DVR can record automatically between two settable times, e.g. between 8 AM and 5 PM. In the func-

tion „Schedule recording“, the start and end time can be set and the automatic recording can be switched 

on. 
Proceed as follows:
•  Use the buttons „4“ and „6“ to choose the submenu „Schedule recording“ and then push the button 

„PLAY/ENTER“ on the DVR or the button „

“ on the IR remote control.

•  Use the buttons „4“ and „6“ to select the desired input position. It is marked red. 
  Use the buttons „8“ and „2“ to set the hours or minutes.
 „Start Time“ = Starting time for recording (hours: minutes)
 „End Time“ = End time for recording (hours: minutes)
•  To switch the automatic recording function on or off, select „ON“ or „OFF“ and then push the button

„PLAY/ENTER“ on the DVR or the button „

“ on the IR remote control. 

 „ON“ = switch on automatic recording function
 „OFF“ = switch off automatic recording function
•  Push the button „MENU/ESC“ on the DVR or the button „MENU“ on the IR remote control repeatedly to

return to the respective previous menu or leave the OSD menu.