Adtran 1200153L1 用户手册
61200.153L1-13
Express XR/XRT Quick Start Guide
5
Chapter 2. Installation
Chapter 2
Installation
INSTALLING THE ADTRAN EXPRESS XR/XRT
This section describes how to connect the Express XR/XRT to a
PC and how to install the Express Configuration Wizard soft-
ware.
PC and how to install the Express Configuration Wizard soft-
ware.
Verify Switch Settings
Dip switches 1 and 2 located on the rear panel of the Express
XR/XRT allow certain settings to be physically configured.
Figure 2-1 shows the location of the dip switches on the rear
panel of the unit.
XR/XRT allow certain settings to be physically configured.
Figure 2-1 shows the location of the dip switches on the rear
panel of the unit.
The factory default position for all switches is down (On) during initial
installation.
installation.
SW 1:
Off (Up)
=
230.4 kbps
On (Down) =
Autobaud (speeds up to 115.2 kbps)
If switch 1 is set to the Off position, the unit is set to operate at a
DTE speed of 230.4 kbps. A special serial COM port using a
16650 UART is required while in this mode. If switch 1 is set to
the On position, the unit will automatically adapt to the DTE
rate (up to 115.2 kbps).
DTE speed of 230.4 kbps. A special serial COM port using a
16650 UART is required while in this mode. If switch 1 is set to
the On position, the unit will automatically adapt to the DTE
rate (up to 115.2 kbps).
In order to configure the Express XR/XRT to operate at 230.4 kbps
with Windows 95 or Windows NT 4.0 Dial-Up Networking, a new
modem must be added from the Modems icon in the Control Panel.
Enter the name for this new connection and select ADTRAN Express
XR
with Windows 95 or Windows NT 4.0 Dial-Up Networking, a new
modem must be added from the Modems icon in the Control Panel.
Enter the name for this new connection and select ADTRAN Express
XR
or XRT 230.4 Kbps & 16650 UART. See the section Installing
Windows 95 Dial-Up Networking.