Kompernass KH 700 用户手册

- 5 -

Hints: 

• Cut the ingredients into approx. 3 cm size pieces

before adding them to the bowl 9.

• The appliance chops the ingredients very fast,

therefore allow the appliance to run only briefly.

• Do not allow the appliance to run for more than

1 minute at a time.

• Should the ingredients get caught up in the bowl

9 or between the blades z:

- Switch off the appliance.
- Remove the lid 0 from the mixing bowl 9.
- Remove the ingredients with a spatula o.

7.2 Remove the cutting and grating

blades from the accessory clip

• Remove the lid 2 from the 

blender jug 4 by turning it 
clockwise.

• Grasp the accessory clip 3

on the handle at the centre of
the retainer 3 with the thumb
and index finger. 

• Pull the accessory clip 3 with the cutting and

grating discs (I-VI) out of the blender jug 4.

• Remove the cutting and 

grating discs (I-VI) from the
holder 3.

7.3 Insert the cutting and grating discs

back into the accessory clip

• Insert the cutting discs (II/III)

in the retainer slots. Begin
with the inner retainer
slots.The lateral flaps with the
elevation in the middle must
point upwards.

Make sure that all the cutting edges are pointing in-
wards.

• Place the shredder (IV/V),

grater (I) and potato-chips
disc (VI) in the storage slot on
the outside.

• Place the accssory clip 3

back in the blender jug 4.

• Place the cover 0 on the li-

quidiser 4 so that the arrows
on the handle of the liquidiser
4 and on the cover 0 point
towards each other. Turn the
cover 0 anti-clockwise until it
sits firmly.

7.4 Working with the cutting and gra-

ting discs

 Caution: 

• The cutting edges are very sharp! Exercise inser-

ting and removing or cleaning the discs! 

• Never use your fingers, spatula, spoon handles

or similar objects for pushing foodstuff through
the filling shaft q!

IB_KH700_E41968_LB6  17.11.2008  14:33 Uhr  Seite 5