Garmin 190-01554-00_0C 用户手册

See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

À

Contact points

Á

Mode and intensity dial

Â

Status LED

À

Contact points

Á

Mode and intensity dial

Â

Status LED

Ã

Charging clip contacts (BarkLimiter Deluxe model only)

With the buckle 

À

 facing outward, insert the end of the collar 

strap through the slot 

Á

 on the collar device.

Pull approximately two-thirds of the collar strap through the 

slot.

Insert the end of the collar strap through the slot 

Â

 on the 

opposite side of the device.

Pull the strap until it is tight across the front of the device.

To prevent corrosion, thoroughly dry the contacts on the collar 

and the surrounding area before connecting the charging clip.

Before you put the collar on the dog, remove the charging clip. If 

you do not remove the clip, it may become detached from the 

collar and become lost.

You should fully charge the battery before you use the device 

for the first time. Charging a fully depleted battery takes about 

two hours. The device will not charge when outside the 

temperature range of 32° to 104°F (0° to 40°C).

Snap the charging clip 

À

 onto the device.

Plug the small end of the power cable into the mini-USB port 

Á

 on the charging clip.

Plug the other end of the power cable into a power source.
The status LED is solid red when the collar is charging.

After the status LED turns solid green, remove the charging 

clip from the collar.

Rotate the dial away from N.

There is a 30-second delay before the device becomes active. 

The status LED indicates the battery charge level for five 

seconds and turns off. After an additional 25 seconds, the unit is 

active. The status LED flashes occasionally to indicate that the 

unit is detecting sound, motion, or vibration.

Rotate the dial to N.

Do not over-rotate the dial. The dial does not rotate past 7.

The dial is intentionally difficult to rotate. This helps to prevent 

accidental rotation while the device is in use on the dog.

Insert a coin or similar object into the slot to rotate the dial.

When the device is active and properly fitted on the dog, it 

detects and corrects barks automatically. You can adjust the 

method and intensity of the corrections.
The status LED flashes briefly when the device detects motion 

or corrects a bark.

Short flash Motion was detected, and no correction was applied.
Long flash

A bark was detected, and a correction was applied.

Introduction

1