Filmtech Film-Tech P-SERIES FILM TRANSPORT P3550 用户手册

17

If the platter should not operate properly, first check the following guide to determine
the cause.  If, after checking the guide, operation is still not proper, contact your dealer
or an authorized theatre equipment service person.

Problem:

Solution:

Platter does not Power-up

Power switch  off 
Platter fuse open
Breaker in console off
Breaker in wall box off
AC line cord plug not properly connected

Platter does not operate in Pay-Out

Pay-out head not fully inserted
Take-up slider not fully seated
Sensor rollers not turning
Motor not engaged or plugged in
Loose, damaged, or missing motor drive puck
Pay-out head out of adjustment
Gradient damaged or missing on target puck
Loose, damaged, or missing internal wiring
Tension sensor not at bottom position

Platter does not operate in Take-up 

Slider not in operating range
Motor not engaged or plugged in
Loose, damaged, or missing motor drive puck
Tension sensor not at bottom position
Loose, damaged, or missing internal wiring
Check for film wrap or jam

Make-Up Table does not Power-up

Power switch off
Main fuse open
Plug not fully seated in power input module
No power at outlet being used
Problem with main board in MUT

Make-Up Table operates incorrectly

Film threaded incorrecly
Exit roller assembly not clamped or correctly aligned with platter deck
Speed control not reset after using the brake
MUT in wrong mode (Make-up vs, Break down)
Wrong spindle assembly (shaft dia) or drive  dog  position
Spindle assembly not fully seated in locking collar