GSI Outdoors PNEG-630 用户手册

On the Competitor Dryer there is only one board to program. This board is called the CPU

Display board. It is mounted to the door of the lower box. To access, open the door and the pro-

gramming jack is located on the back of this board. To program, follow the instructions below.

  1. Turn the control power on the dryer to the off position.

  2. Locate the programming jack (J2 connector) on back of board.

  3. Unplug the communications cable that is connected to that connector. This is the cable that

      runs from the CPU/Display board and IO Board.

  4. Connect the DB-9 connector from the Palm Pilot to the series 2000 cable.
  5. On the Palm Pilot select the program for that particular board and tap on it.
  6. Turn the dryer control power back on.
  7. The programming process should begin, it will erase the present program and start the new
      program.
  8. A screen will come up telling you when the transfer of software is complete.
  9. When the process is complete turn dryer control power off, remove the connector from the
      board and plug the communications cable back on to the CPU/Display board.
10. Turn on the dryer and the opening screens should indicate the latest version of software.

If ordering Palm Pilot from GSI there are two kits available:

D03-0692 ( Palm Flash Program Kit Deluxe )
D01-1771  Series 2000 Programming Cable
D03-0688  Palm Pilot IIIC (color)
D03-0694  Palm Pilot Hot Sync Cable
D03-0695  Palm Flash 9 Pin M-M Adapter
D03-0709  Disk, CD-Rom Palm Flash Software
D03-0693 ( Palm Flash Program Kit Economy )

D01-1771  Series 2000 Programming Cable
D03-0689  Palm Pilot M100 (black & white)
D03-0695  Palm Flash 9 Pin M-M Adapter
D03-0709  Disk, CD-Rom Palm Flash Software