North Star GPS/WASS CHART NAGIVATOR GM9571M 用户手册

下载
页码 70
SECTION TWO: Installing and wiring the 957
957 Installation Manual, Revision C1
Page 15
Electrical power
requirements
Power source
The 957 is a negative-ground system that’s reverse-polarity 
protected. DC power is required from a 10-volt minimum to a 
36-volt maximum using at least 16-gauge connecting wire.
 
Connecting the 957 to
ship’s power
A 10-foot power cable is shipped with the 957 system. You can 
lengthen this cable to a maximum of 25 feet: 
for a cable length up to 15 feet, the power connections 
must use 16-gauge connecting wire or heavier
for a cable length from 15 to 25 feet, use 14-gauge 
connecting wire or heavier 
If you lengthen the power cable, use an external fuse at the 
battery end as an added safety precaution. The fuse size 
should match the size of the wiring on the vessel
. See the 
NMEA or the American Boating and Yachting Counsel 
specifications to find the correct fuse to use with your cable. 
For the best protection from noise, connect the power cable 
directly to the battery or dedicated electronics buss. The green 
ground wire should be connected to ship’s ground directly.
AUX (Auxiliary)
(6-pin auxiliary NMEA
port)
RS-422/NMEA input/output ----->
Northstar 490 echo sounder (optional)
- or -
A second 957 (or to a Northstar 952/951/
941) for the waypoint-and-route transfer
function
PWR (Power)
Power 
10 to 36 VDC
VGA 
(15-pin port)
Video output
Remote display 
VIDEO 
(coaxial)
Video input
Any NTSC-compatible device 
Table 1: Interface connector functions (continued)
Connector name 
Connector function(s)
Connects to...
CAUTION!
As a good safety practice, Northstar strongly
recommends that you connect the 957 to a circuit
breaker or 20-amp fuse at the power source
(battery).