Bissell SpotBot Pet 33N8T 业主指南

下载
页码 12
Getting ready
1. To fill the clean water/solution tank:
 
 
a. Remove the clean water tank by lifting it 
straight up and then away from the unit. 
 
 
b. Unscrew the cap at the bottom of the 
clean water tank.
2. There are 2 ways you can fill and use the tank:
 
 for common stains such as dirt, grime, pet 
or oily stains, use the fill lines on the left side 
of the tank and fill with bissell 2X com-
pact formula (trial size included) and water.
 
 for dye based stains such as coffee, fruit 
juices, cola and red wine, use the fill lines  
on the right hand side of the tank and fill with 
bissell 2X compact formula and OXYgen 
boost formula (trial sizes included) and water. 
Do not boIl oR mIcRoWaVE WatER.
3. Tighten black cap on bottom of clean tank 
and replace.
How to begin
Using the automatic Smart System™
Your new spotbot features an Automatic smart 
system that takes the guesswork out of spot and 
stain removal. With the touch of a button, you 
can select the cleaning cycle to use your pre-
ferred method of cleaning.
1. Surface Stain cycle This cycle has been 
designed for stains that are on the surface of 
your carpeting. This cycle will run for approxi-
mately 3 minutes.
2. Set-In Stain cycle Use on stains that have had 
a period of time to set-in. These are typically the 
most difficult stain types to remove. This cycle 
runs for approximately 6 minutes.
3. manual/Hose by selecting this option you can 
clean spots and stains manually on surfaces such 
as upholstery, stairs, car interiors, or any other 
hard to reach area.  
4. pause/Resume if you press the pause/resume 
button once, it will pause the cleaning cycle. Press 
again to resume your current cleaning cycle.  
5. Stop by pressing the red stop button, you 
will stop the cleaning cycle completely. To begin 
cleaning again, you will need to start over and 
select a cleaning cycle.
6. Status Indicator lights Will give you a visual 
update on the cleaning cycle. During a clean-
ing cycle you will hear changes in the sound of 
the machine that correspond with a given step. 
When the cleaning cycle is complete, the Finish 
light will illuminate and you will hear a series 
of “beeps”. Press the sTOP button to turn the 
machine off. The machine will not  
beep when turned off.
Operations
www.bissell.com   
   800.237.7691
WaRnInG
Keep spray away from face. Failure to do  
so may result in personal injury.
6
1a.
3.
2.
1b.
»  Dry vacuum the area first, before spot 
cleaning with the SpotBot.
»  Some spots and spills require that you 
pick up the chunky debris with a rag or 
towel before you begin cleaning in the 
automatic or manual cycles.
Tips