M-S Cash Drawer A794 用户手册
Chapter 6: Programming Information
A794 Owner’s Guide
December 1999
62
Perform Partial Knife Cut
ASCII
SUB
ESC m
Hexadecimal
1A
1B 6D
Decimal
26
27 109
Partially cuts the receipt. The default setting leaves 5 mm. (0.20 inch) of paper on
the left edge. (See Setting Partial Cut Distance in Diagnostics.)
the left edge. (See Setting Partial Cut Distance in Diagnostics.)
There are two codes (Hex 1A or 1B 6D) for this command and both codes perform the
same function.
same function.
Formulas
The cut edge is 144 dot rows or 18 mm (0.71 inch) above the print station.
Exceptions
The command is valid only at the beginning of a line. ASCII SUB, (0x1A), is ignored in
TM-T88 Emulation. Line Feed is executed first, if the buffer is not empty.
TM-T88 Emulation. Line Feed is executed first, if the buffer is not empty.
Generate Tone
ASCII
ESC BEL
Hexadecimal
1B 07
Decimal
27 7
Generates an audible tone. Performed by the printer to signal certain conditions.
Related Information
This command is recognized in A793 Emulation and A794 Native Mode, ignored in
TM-T88 Emulation.
TM-T88 Emulation.
Select Peripheral Device (for Multi-Drop)
ASCII
ESC = n
Hexadecimal
1B 3D n
Decimal
27 61 n
Value of n:
0 (bit 0), device not selected
1 (bit 0), device selected
1 (bit 0), device selected
Default:
1 (bit 0), device selected
Selects the device to which the host computer sends data.
Related Information
Other bits of n (1-7) are undefined and ignored.
When the printer is disabled by this command, it ignores transmitted data until the
printer is re-enabled by the same command.
printer is re-enabled by the same command.