Siemens AMILO A Series 用户手册

A Series 

 

English - 8 

10600416168 

If no display appears on the screen and the power-on indicator flashes, this may have the following 
causes: 

The screen power-management feature may be active. 
►  Press any key to activate the display. 

The notebook is in Standby or Suspend mode. 
►  Press the ON/OFF switch to end the Standby or Suspend mode. 

The display angle or brightness may not be properly adjusted. 
►  Change the display angle and set the brightness by pressing the key  Fn  together with the key 

 F8  (darker) or  F7  (brighter) until the picture appears correct. 

The notebook is set so that the picture only appears on the external screen. 
►  Press the key combination  Fn  +  F4  to switch over the display to the LCD screen or to 

specify the simultaneous display on the LCD screen and the external screen. 

If you are operating the notebook with a battery, you may have overlooked the reference to 
the low battery level and the notebook has switched over to Standby mode. 
►  Connect the power adapter. 
►  Press the ON/OFF switch. 

You may have an application running that consumes a great deal of power due to frequent 
accessing of the hard disk or CD-ROM drive. 
►  Use the power adapter as frequently as possible. 

The maximum brightness may have been set for the screen. 
►  Set the screen somewhat darker with the key  Fn  and the key  F8   to reduce the power 

consumption. 

The power-management features have been deactivated. 
►  Check the settings in the BIOS Setup Utility, and adjust the parameters.