AstroStart Security System VSS-113 用户手册

vehicle, the system will trigger as the door is opened and closed. This is how the system works to

combat intersection carjacking. To protect against parking lot carjacking, arm the VRS

before

leaving the vehicle. The system will now trigger automatically the next time you or anyone drives

the vehicle. This helps to protect the vehicle if someone takes your keys and remote transmitter

by force in a parking lot.

Note: If the VRS

system is armed while operating the vehicle and not disarmed prior

to leaving the vehicle, it is still armed and will trigger the next time the vehicle is driven.

VRS

TRIGGERED SEQUENCE

Fifteen seconds after the last door has closed, the system’s status LED will begin flashing. This

delay is intended to allow you time to distance yourself from your vehicle in the event of a

carjacking.

Forty-five seconds later, the siren begins chirping and the parking lights begin flashing. This time

could be used to notify authorities that your vehicle has been hijacked, and tell them what the

VRS

will do next.

Fifteen seconds after the siren chirps begin, the siren’s output will change to a continuous blast.

From this point on, when the ignition key is turned off, the VRS

will immediately turn on the

starter kill. This will prevent the vehicle from being restarted, thus immobilizing it at that spot.

Three minutes after the constant siren output begins, the flashing parking lights and the siren will

stop. The starter kill will remain active until the system is disarmed. If the door is opened or the

ignition is turned off and on in an attempt to restart the car, the siren and light flashing will begin

again.

ISARMING THE

VRS

Take the time to familiarize yourself with the VRS

triggering sequence and the disarm procedure.

It is important to recognize and identify the VRS

trigger sequence and know how to disarm it in

case of accidental activation.

Once the VRS

is armed, it does not disarm automatically. You must disarm it the next time you

operate the vehicle. You must disarm it with one of the following procedures:

If the system has not entered the triggered sequence (siren has not started chirping):

1. Turn the ignition on.

2. Press on the transmitter for one second.

The lights will flash and the siren will chirp twice.

STROFLEX

LECTRONICS

– A