Waterford Appliances EMERALD E63-NG1 用户手册

10

Waterford E63-1 EMERALD Freestanding Gas Stove

2) Loosen the "IN" (# 7) and/or "OUT" (# 6)

pressure tap(s), turning counterclockwise
with a 1/8" wide flat screwdriver.

3) Attach manometer to "IN" and/or "OUT"

pressure tap(s) using a 5/16" ID hose.

4) Light the pilot and turn the valve to "ON"

position.

5) The pressure check should be carried out

with the unit burning and the setting should
be within the limits specified on the safety
label.

6) When finished reading manometer, turn off

the gas valve, disconnect the hose and
tighten the screw (clockwise) with a 1/8"
flat screwdriver. Screw should be snug,
but do not over tighten.

1) Gas cock knob

2) Manual high/low adjustment

3) Pilot Adjustment

4) Thermocouple Connection

5) Main Operator

6) Outlet Pressure Tap

7) Inlet Pressure Tap

8) Pilot Outlet

9) Main Gas Outlet

10) Flange Securing Screw Holes

11) Alternative TC Connection Point

12) Thermoelectric Unit

13) Additional Valve Mounting Hole

4) Carefully remove the logs, embers and

rockwool.

5) Remove burner. See diagram below.

6) Remove and discard the 3 pressure regu-

lator mounting screws (A), pressure reg-
ulator tower (B) and diaphragm (C).

7) Insure that the rubber gasket (D) is properly

positioned and install the new HI/LO pres-
sure regulator assembly   to the valve using
the new screws (E) supplied with the kit.
Tighten screws securely.

8) Pull off the pilot cap to expose the pilot

orifice.

3) Open the front door.  Open the right side

door and there is a cutout in the heat shield
through which can be seen a wing nut
threaded on to a stud attached to the front
door. Loosen this nut by turning it counter-
clockwise.

Conversion Kit Contains:

Qty.

Part # Description

1

910-018

SIT Conversion Kit-50%
Turndown LP

1

910-037

LP Injector (Pilot Orifice)

1

904-641

Burner Orifice #50

1

908-175

E63/E65 Decal "Converted to
Propane"

1

908-528

Red "PROPANE" label

1

908-780

Instruction Sheet

1) Shut off the gas supply.

2) Open the valve door and remove the control

panel.