Bunn AFPO-3 SL 用户手册

11

Location:

 

The fuse holder is located on the lower right front 

of the autofill box just to the left of the power cord.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Remove cap and fuse from fuse holder.

3.  Remove fuse from the cap.

4.  Check for continuity through the fuse.

If continuity is present, reinstall the fuse, the fuse is 

operating properly.

If continuity is not present, replace the fuse.

 

FIG. 4 FUSE HOLDER

P1516

Removal  and Replacement:

Fuse:

1.  Remove the cap from the fuse holder.

2.  Remove fuse from the fuse holder and inspect. If 

blown, discard.

3.  Install new 10 amp fuse in the fuse holder.

4.  Reinstall fuse holder cap.

Fuse Holder:

1.   Disconnect the dispenser from the power source.

2.  Disconnect  the  wires  from  the  rear  of  the  fuse 

holder.

3.  Remove  the  nut  securing  the  fuse  holder  to  the 

front of the main mounting panel.

4.  Push  the  fuse  holder  through  the  hole  in  the 

panel.

5.  Install new fuse holder and fuse through the hole 

in the panel.

6.  Secure the fuse holder to the panel. 

7.  Refer to Fig. 5 and reconnect the wires. 

BLK from Main

Wiring Harness

BLK to Main

ON/OFF Switch

FIG. 5 FUSE HOLDER TERMINALS

P1331

41093 040408