Whirlpool MAYTAG W10101293A 用户手册

3. Attach the brackets to the back of the laundry tower using the 

screws (provided). Align the brackets so that the latch is 
pointing up.

4. Attach the console to the laundry tower. Align the locators 

with the brackets and push down until the latches snap into 
place and the magnets on the bottom of the console attach to 
the top panel.
NOTE: Once installed, the console can be removed only by 
removing the 2 console screws.

1. Using two or more people, situate the laundry tower near its 

final location. Open the drawers to remove any contents 
stored inside.

2. To determine how far to extend the leveling feet, measure the 

height of the washer and/or dryer you are installing the laundry 
tower next to or between. 
NOTE: Refer to the laundry tower dimensions in “Location 
Requirements.”

3. Place a piece of cardboard on the floor and, using two or more 

people, lay the laundry tower on its side. 

4. Turn all four feet out to the dimension determined in Step 2.
5. Using two or more people, return the laundry tower to the 

upright position.

6. Check the laundry tower height and levelness and adjust the 

feet as needed.

7. Once the laundry tower is at the appropriate height and is 

level, use a 

⁹⁄₁₆" (14 mm) open-end wrench to securely tighten 

all four locknuts against the laundry tower.    

8. Using two or more people, slide the laundry tower into its final 

location and confirm height and levelness.

■

Use a soft damp cloth or sponge to wipe up any spills. 
Occasionally wipe the surfaces of your laundry tower to help 
keep it looking new.

■

Use mild soap and water; do not use abrasive products.

■

NOTE: Do not lift the front of the console off the laundry tower 
without first removing the console screws.