Whirlpool W10388775A 用户手册

4.  Install the two hinges to the front panel of the dryer using  

4 screws. Use the non-slotted side to attach the hinge  

to the front panel.

  

Install screws in top hinge holes in the door. Do not tighten 

screws. Leave approximately 1/4" (5 mm) of screw exposed

.

6.  Hang door by placing screw heads into top slotted holes of 

hinges and slide door down. Align bottom screw holes in hinge 

and door. Install two bottom screws. Tighten all hinge screws.

7.  Close door to engage door strike.

 

■

There may be two household fuses or circuit breakers  

for the dryer. Check that both fuses are intact and tight,  

or that both circuit breakers have not tripped. Replace  

the fuse or reset the circuit breaker. If the problem  

continues, call an electrician.
is the correct power supply available? 

 

■

Electric dryers require a 240-volt power supply. Check  

with a qualified electrician.
Was a regular fuse used? 

 

■

Use a time-delay fuse.

 

■

The drum may be turning, but you may not have heat. Elelctric 

dryers use two household fuses or circuit breakers.Replace 

the fuse or reset the circuit breaker. If the problem  

continues, call an electrician.

 

■

Was the drying cycle interrupted by a power failure? 

Press and hold START/PAUSE to restart the dryer.
“l2” Diagnostic Code (low or no line voltage condition):

 

■

 

The drum will turn, but there may be a problem with your 

home power supply keeping the dryer’s heater from turning 

on. The dryer will continue to run when this diagnostic code  

is present. 

 

Press any key to clear the code from the display and return  

to the estimated time remaining. 

 

   Try the following:  

Check to see if a household fuse has blown or circuit breaker 

has tripped. Electric dryers use two household fuses or 

breakers. Replace the fuse or reset the circuit breaker. 

 

Confirm the power cord is properly installed. Refer to 

“Electrical Connection” for details. 

 

Select a Timed Dry heated cycle, and restart the dryer. 

 

If the message persists, consult a qualified electrician.
“AF” (low airflow condition): 

 

■

The dryer will continue to run when this diagnostic code is 

present. Press any key to clear the code from the display and 

return to the estimated time remaining. 

 

  Try the following:  

Clean lint screen. 

 

Check to see if the vent run from the dryer to the wall is free 

of lint and debris. 

 

Confirm the exterior vent exhaust hood is free of lint and 

debris. 

 

Confirm your vent system falls within the recommended run 

length and number of elbows for the type of vent you are 

using. Refer to “Plan Vent System” for details.