Whirlpool W10096987A 用户手册

If using a power supply cord:
Use a UL listed power supply cord kit marked for use with  

clothes dryers. The kit should contain:

A UL listed 30-amp power supply cord, rated 120/240 volt 

 

■

minimum. The cord should be type SRD or SRDT and be  

at least 4 ft. (1.22 m) long. The wires that connect to the  

dryer must end in ring terminals or spade terminals with 

upturned ends.
A UL listed strain relief.

 

■

If connecting by direct wire:
Power supply cable must match power supply (4-wire or 3-wire) 

and be:

Flexible armored cable or nonmetallic sheathed copper cable 

 

■

(with ground wire), covered with flexible metallic conduit. All 

current-carrying wires must be insulated.
10-gauge solid copper wire (do not use aluminum). 

 

■

At least 5 ft. (1.52 m) long.

 

■

Then choose a 4-wire power supply cord with 

ring or spade terminals and UL listed strain 

relief. The 4-wire power supply cord, at least  

4 ft. (1.22 m) long, must have 4 10-gauge solid 

copper wires and match a 4-wire receptacle of 

NEMA Type 14-30 R. The ground wire (ground 

conductor) may be either green or bare. The 

neutral conductor must be identified by a white 

cover.

Then choose a 3-wire power supply cord with 

ring or spade terminals and UL listed strain 

relief. The 3-wire power supply cord, at least  

4 ft. (1.22 m) long, must have 3 10-gauge solid 

copper wires and match a 3-wire receptacle of 

NEMA Type 10-30R.

To avoid damaging floor, use a large flat piece of cardboard 

from dryer carton; place under entire back edge of dryer. 

Firmly grasp dryer body (not console panel) and gently lay 

dryer down on cardboard.

Examine leveling legs, find diamond marking. Screw legs into  

leg holes by hand, use a wrench to finish turning legs until 

diamond marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is 

close to its final location. Leave enough room for electrical 

connection and to connect the exhaust vent.