Whirlpool Gold 7MGGW9868KL0 用户手册

Select one of the Automatic or Timed Cycles. Use the Heavy 
Duty, Towels/Cotton or Normal cycles to dry most 
heavyweight and medium weight loads. See “Cycles.”

For Automatic Cycles, select one of the 5 levels of dryness  
by pressing the up or down arrows. See “Cycles.”

For Timed Cycles only, select one of 6 temperature settings. 
See “Cycles.” 

Select the WRINKLE SHIELD™ setting, if desired. See 
“Additional Features.”

Select the Cycle Signal, if desired. The signal is helpful when 
drying permanent press or synthetics. Promptly remove these 
items from the dryer at the end of the cycle to prevent 
wrinkles. See “Additional Features.”

Push the START pad.

You can stop your dryer anytime during a cycle.

Press STOP/CANCEL twice.

Close the door.

Push START.

Open the door or press STOP/CANCEL once. Close door and 
press START to resume the cycle.

Drying will continue from where the cycle was interrupted 

if you close the door and press START within 5 minutes. If the 
cycle is interrupted for more than 5 minutes, the dryer will shut 
off. You will need to select new cycle settings before restarting 
the dryer.

Load clothes loosely into the dryer. Do not pack the dryer. Allow 
space for clothes to tumble freely. The following chart shows 
examples of balanced loads that would allow for proper tumbling. 

Select the correct cycle and temperature for your load.

■

Press firmly in the center of the pad.

■

The indicator light next to the pad will light up when a 
selection is valid.

■

A short tone will sound when a selection is valid.

■

Three short tones will sound when a selection is not valid.

■

After your first use, your dryer “remembers” the Dryness 
level, WRINKLE SHIELD™ setting and Cycle Signal setting 
you selected.

■

If you press and hold the Temp selector, the Cycle Signal 
selector or the More Dry or Less Dry arrows, you will advance 
the settings.

■

If you press and hold the Less Time or More Time arrows in 
the Timed Cycles, the time will advance in 5-minute intervals.

■

Follow care label directions when they are available.

■

If desired, add a fabric softener sheet. Follow package 
instructions.

■

Remove the load from the dryer as soon as tumbling stops to 
reduce wrinkling. This is especially important for permanent 
press, knits, and synthetic fabrics.

■

Cool Down tumbles the load without heat during the last few 
minutes of all cycles. Cool Down makes the loads easier to 
handle.

■

Use the Timed Dry cycle with the Air Only (no heat) 
Temperature setting for rubber, plastic or heat-sensitive 
fabrics.

If your dryer has multiple heat settings:

■

Use a high heat setting for drying heavyweight items such as 
towels and work clothes.

■

Use a low to medium high heat setting for drying medium-
weight items such as sheets, blouses, dresses, underwear, 
permanent press fabrics, and some knits.

■

Use an extra low heat setting for drying lightweight items 
such as lingerie.

■

Use a no heat (air) setting for rubber, plastic or heat-sensitive 
fabrics.

■

Line dry bonded or laminated fabrics.

If you are unsure of the temperature to select for a load, select 
the lower setting rather than the higher setting.

 If you have questions about drying temperatures for 

various loads, refer to the care label directions.

 

3 pair of pants, 4 pair of jeans,
2 pair of overalls, 3 shirts   

3 camisoles, 1 robe, 4 slips,
6 undergarments, 2 sets of sleepwear,
1 child’s outfit

10 bath towels, 10 hand towels,
14 washcloths, 1 bath mat

3 double sheets, 4 pillowcases, 
8 T-shirts, 6 pair of shorts, 2 blouses,
8 handkerchiefs