Whirlpool 8535840 用户手册
3
Parts needed for
installation
installation
Check local codes and see electrical
and venting requirements, Panels A
and B, before purchasing parts.
Determine if you will need to purchase
a power supply cord kit or power
supply cable.
and venting requirements, Panels A
and B, before purchasing parts.
Determine if you will need to purchase
a power supply cord kit or power
supply cable.
Electrical
If using a power supply cord:
Dryer power supply cord must be:
• U.L.-listed
• 120/240-volt minimum
• 30-ampere
• Type SRD or SRDT
• At least 4 feet long
The wires that connect to the dryer
must end in ring terminals or spade
terminals with upturned ends.
must end in ring terminals or spade
terminals with upturned ends.
The receptacle must be located within
3 feet of the top, back center of the
control console.
3 feet of the top, back center of the
control console.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to do so can result in death or
fire.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to do so can result in death or
fire.
WARNING
Venting system
Four-inch heavy metal exhaust vent
and clamps must be used. Dura Safe™
vent products are recommended.
and clamps must be used. Dura Safe™
vent products are recommended.
Dura Safe vent products can be
purchased from your dealer or by
calling Whirlpool Parts & Accessories
1-800-442-9991, Mon-Fri: 8am to 9pm
(CST), Sat: 9am to 4:30pm (CST).
Visit our internet site at
http://www.whirlpoolappliances.com/
accessories
purchased from your dealer or by
calling Whirlpool Parts & Accessories
1-800-442-9991, Mon-Fri: 8am to 9pm
(CST), Sat: 9am to 4:30pm (CST).
Visit our internet site at
http://www.whirlpoolappliances.com/
accessories
See Page 11 for more information.
Exhaust hood
Do Not use exhaust hoods with
magnetic latches.
magnetic latches.
4"
4"
2-1/2"
Preferred Acceptable
Mobile home installations
require:
require:
• Mobile Home Installation Kit, Part
Number 346764*
• Metal exhaust system hardware*
Floors sloped greater than
1 inch:
1 inch:
Require Extended Dryer Feet Kit, Part
No. 279810*.
No. 279810*.
*Available for purchase from your
dealer.
If your outlet
looks like this:
Choose this
power supply cord:
4-wire
receptacle
(14-30R)
4-wire power supply cord
with ring or spade terminals
and U.L.-listed strain relief
3-wire power supply cord
with ring or spade terminals
and U.L.-listed strain relief
3-wire
receptacle
(10-30R)
If connecting by direct wire:
Power supply cable must match power
supply (4-wire or 3-wire) and be:
supply (4-wire or 3-wire) and be:
• flexible armored or non-metallic
sheathed copper cable (with ground
wire). All current-carrying wires must
be insulated. See Panels D and E.
wire). All current-carrying wires must
be insulated. See Panels D and E.
• 10-GAUGE SOLID COPPER WIRE.
(Do not use aluminum.)
• at least 4 feet long.