Whirlpool Slide-Out Range Hood 用户手册

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Level

■

Drill

■

1

¹⁄₄" drill bit

■

³⁄₈" (8 mm) nut driver or ratchet

■

Pencil

■

Pliers

■

Wire stripper or utility knife

■

Tape measure or ruler

■

Caulking gun and weatherproof caulking compound

■

Phillips screwdriver

■

Flat-blade screwdriver

■

Saber or keyhole saw

■

Vent clamps

■

Metal snips

■

Home power supply cable

■

Two 

¹⁄₂" (12.7 mm) UL listed or CSA approved strain reliefs

■

1 wall or roof cap 

■

Metal vent system

■

Charcoal Filter Kit Part Number 883140. See “Assistance or 
Service” section to order.

■

Wood filler strips for cabinets with recessed bottoms. Length 
and thickness determined by recess dimensions. See 
“Prepare Location” section.

■

Two, 1" x 1" x 5" (25.4 x 25.4 x 127 mm) wood pieces for 
cabinet floor. See “Prepare Location” section.

■

Four, 1

¹⁄₄" (31.8 mm) wood screws

Remove parts from packages. Check that all parts are included.

■

2 screws

■

Damper

■

Plastic cover (used for customized front panel)

■

Hardware package

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the 
installer’s responsibility to comply with installation clearances 
specified on the model/serial rating plate. The model/serial rating 
plate is located behind the left filter on the rear wall of the range 
hood.

Range hood location should be away from strong draft areas, 
such as windows, doors, and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given 
dimensions provide minimum clearance. Consult your cooktop/
range manufacturer installation instructions before making any 
cutouts.

Grounded electrical outlet is required. See “Electrical 
Requirements” section.

The range hood is factory set for vented installations through the 
roof or wall. For non-vented (recirculating) installations see “Non- 
Vented (recirculating) Installation Through the Soffit/Cabinet” in 
the “Prepare Location” section. Charcoal Filter Kit Part Number 
883140 is available from your dealer or an authorized parts 
distributor.

All openings in ceiling and wall where range hood will be installed 
must be sealed.

The installation of this range hood must conform to the 
Manufactured Home Construction Safety Standards, Title 24 
CFR, Part 328 (formerly the Federal Standard for Mobile Home 
Construction and Safety, title 24, HUD, Part 280) or when such 
standard is not applicable, the standard for Manufactured Home 
Installation 1982 (Manufactured Home Sites, Communities and 
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local 
codes.