Well Traveled Living 60354 用户手册

下载
页码 5
Thank you for purchasing a Fire Sense Electric Fireplace.
Important:
 
Read all instructions and warnings carefully before starting installation.
Failure to follow these instructions may result in a possible electric shock, fire hazard and 
will void the warranty.
Read all instructions before using this appliance.
This  fireplace  is  hot  when  in  use.  To  avoid  burns,  do  not  let  bare  skin  touch  hot 
surfaces.  If  provided,  use  handles  when  moving  this  appliance.  Keep  combustible 
materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 
feet from the front and sides of this appliance.
Caution: 
Extreme  caution  is  necessary  when  any  heater  is  used  near  children  or 
disabled persons.  Never leave any heater unattended.
Always unplug this appliance when not in use.
Do  not  operate  any  heater  with  a  damaged  cord  or  plug  or  after  the  appliance 
malfunctions, or has been dropped or damaged in any manner.
Any repairs to this appliance must be carried out by a qualified service person.
Under  no  circumstances  should  this  appliance  be  modified.  Parts  having  to  be 
removed for servicing must be replaced prior to operating this appliance again.
Do not use outdoors.
This appliance is not intended for use in bathrooms, laundry areas and similar indoor 
locations.  Never  locate  this  appliance  where  it  may  fall  into  a  bathtub  or  otherwise 
become exposed to water.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. 
Arrange cord away from traffic areas and where it will not be tripped over.
To disconnect this appliance, turn controls to the off position, them remove the plug 
from the outlet.
Connect to properly grounded outlets only.
This appliance, when installed must be electrically grounded in accordance with local 
codes, and the National Electrical Code, ANSI/NFPA No. 70.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this 
may cause an electric shock, fire or damage the appliance.
To prevent possible fire, do not block air intakes or exhaust in any manner. Do not use 
on soft surfaces, like a bed, where openings may become blocked.
This appliance has hot and arching or sparking parts inside. Do not use it in areas 
where gasoline, paint or flammable liquids are used or stored. This appliance should 
not  be  used  as  a  drying  rack  for  clothing,  nor  should  Christmas  stockings  or 
decorations be hung on or near it.
INSTALLATION INSTRUCTIONS – GENERAL
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
A 15 Amp, 110 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this 
appliance. The fireplace must be on a dedicated circuit as other appliances on the same 
circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in opera-
tion. The unit comes standard with a 6.5 ft long 3 wire cord, exiting out the back of the 
fireplace. Plan the installation to avoid the use of an extension cord. If an extension cord 
must  be  used,  it  must  be  a  minimum  14  gauge,  3  wire  with  grounding  type  plug  and 
connector and rated not less than 2025 watts. The extension cord shall not be more than 
20 ft in length.
ELECTRICAL CONNECTION
SPECIFICATIONS
Dimensions LxWxH
Net Weight
Voltage
Frequency
Watts
Heater Rating
15.76” x 26” x 28.37”
59.40 lbs
110V
60 Hz
1350 W
4600 BTU
WARNING: 
Electrical  outlet  wiring  must  comply  with  local  building  codes  and  other 
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: 
Do not use this fireplace if any part of it has become wet. Immediately call a 
qualified  service  technician  to  inspect  the  fireplace  and  replace  any  part  of  the  electrical 
system which has been wet.
17.
18.
Use this appliance only as described in this manual. Any other use not recommended 
by the manufacturer may cause fire, electric shock or injury to persons.
Avoid the use of an extension cord because the extension cord may overheat and 
cause a risk of fire. However, if you have to use an extension cord, the cord shall be 
14 gauge minimum size and rated not less that 2025 watts. The extension cord must 
be a three wire cord with grounding type plug and cord connector. The extension 
cord shall not be more than 20 feet in length.