Benq PE5120 用户手册
15
Using the projector and remote control
Using the projector and remote control
Preparations
Turning the power on
1.
Check that the Power indicator lights orange after power has been
applied.
applied.
2.
Press and hold the Power button on the projector or remote control
to turn the projector on. The Power indicator light flashes for about
30 seconds during warm up, then remains constantly on (and the
projector starts projecting) when ready.
to turn the projector on. The Power indicator light flashes for about
30 seconds during warm up, then remains constantly on (and the
projector starts projecting) when ready.
3.
Press Source on the projector or one of the Source buttons on the
remote control to select your desired input signal. A message shows
on the screen when the port is being searched.
If you would like to change the input signal, please see below.
remote control to select your desired input signal. A message shows
on the screen when the port is being searched.
If you would like to change the input signal, please see below.
Switching input signals
To sequentially select input signals, press one of the Source buttons on the
remote control or Source on the projector.
remote control or Source on the projector.
The selected source will be displayed at the bottom right of the screen for 3
seconds.
seconds.
Activate the Source Scan function in the Advance menu if you want the
projector to automatically search input ports. It may take a few
seconds for the projector to search for input signals.
projector to automatically search input ports. It may take a few
seconds for the projector to search for input signals.
Adjusting the image
Adjusting the angle height
The projector is equipped with 1 front quick-release adjuster foot and 2
rear adjuster feet. These adjusters change the image height and
projection angle. To adjust the projector:
rear adjuster feet. These adjusters change the image height and
projection angle. To adjust the projector:
1.
Lift the projector up and press the adjuster button to release the
adjuster. The front adjuster foot will drop into position and lock
into place when you release the button. It can lift the projector by
up to 15 degrees. Manually screw it up or down for fine height adjustment.
adjuster. The front adjuster foot will drop into position and lock
into place when you release the button. It can lift the projector by
up to 15 degrees. Manually screw it up or down for fine height adjustment.
2.
Screw the rear adjuster feet to adjust the horizontal angle so that the projector is stable and the projection
is level.
is level.
1.
Turn all of the connected equipment on.
2.
Remove the lens cap.
3.
Plug the supplied power
cord into the AC inlet on
the rear of the projector.
cord into the AC inlet on
the rear of the projector.
4.
Plug the power cord into
a wall socket and turn the
wall switch on.
a wall socket and turn the
wall switch on.