BENDIX TCH-013-007 产品宣传页

下载
页码 2
Technical 
Bulletin
Bulletin No: TCH-013-007 
Effective Date:  10/23/03
Cancels:  NA
Page: 1 of 2
Subject:  
Bendix
®
 
EC-30T™ ECU Product Recall Campaign
The EC-30T electronic controller is a part of a voluntary recall campaign, recall number:
03E-043. The EC-30T is the electronic controller of the Bendix MC-30 Trailer ABS Controller
Assembly.
What You Need To Do
All vehicle manufacturers, dealers and distributors should stop selling any EC-30T or MC-30
that does not include an MC-30 Fuse Adapter Assembly.  Please make your customers aware of
the recall campaign.  All new EC-30Ts and MC-30s will be shipped with an MC-30 Fuse
Adapter Assembly.
The Problem
Bendix has determined that if the trailer-mounted ABS warning lamp circuit experiences an
electrical short for reasons unrelated to the EC-30T, and the short is not repaired, the high side
power switch inside the ECU may eventually become thermally stressed and experience an
electrical short.  The high side power switch controls the illumination of the trailer-mounted
ABS warning lamp.
If the power switch shorts, it can result in an over-current condition in the ECU and lead to excessive heat, smoke
and in rare cases, even fire in the ECU, the connector or the pigtail wiring harness.  The fire that could result from
this situation involves an unreasonable risk to motor vehicle safety.  The service, parking and emergency braking
of the trailer and tractor are not affected by this condition.
The Cause
The electrical short must occur in the wiring between the ECU and the warning lamp.  Failure cannot be caused
by any wiring defect on the ground side of the warning lamp.
How to Identify the EC-30T
The EC-30T can be identified by the black plastic enclosure imprinted
with the Bendix® logo, and containing a single 30-pin connector and
an LED diagnostic display.
EC-30T or MC-30s in Inventory
If your current inventory contains MC-30 or EC-30T, an MC-30 Fuse
Adapter is required for installation.  Fuse adapter kits are available in
3, 4 and 5-pin configurations.  To identify the correct piece number
needed check the connector of the pigtail harness that connects to the
chassis harness.  See figure 2 for kit piece numbers.  To order the
MC-30 Fuse Adapter Kit, please call the Recall Assistance Center at
1-800-478-1793 between 8:00am to 5:00pm E.S.T.
Final
Design
or
Figure 1 - MC-30™ Trailer
ABS Controller Assembly
EC-30T™ ECU
Figure 2 - Fuse Adapter Assemblies
5-Pin
(Kit Pc. No. 801694)
4-Pin
(Kit Pc. No.
801730)
3-Pin
(Kit Pc. No.
801729)
Interim
Design