Whirlpool Conservator BYCWD6274W3 用户手册

Your washer/dryer must be properly installed and vented for the 
dryer to achieve maximum drying efficiency and shorten drying 
times. Use the minimum recommended installation clearances 
(found in your Installation Instructions) to avoid blocking the flow 
of combustion and ventilation air. See the Installation Instructions 
for more information.

If the washer/dryer is not properly installed and vented, it will not 
be covered under the warranty.

NOTE: Service calls caused by improper venting will be paid for 
by the customer, whether it was a paid installation or self-
installed. 

1. Do not use plastic vent or metal foil vent. Use 4 in. (10.2 cm) 

metal or flexible metal vent. Do not kink or crush flexible metal 
vent. It must be completely extended to allow adequate 
exhaust air to flow. Check vent after installation. Refer to your 
Installation Instructions for proper length requirements of vent.

2. Use a 4 in. (10.2 cm) exhaust hood.
3. Use the straightest path possible when routing the vent.

4. Use clamps to seal all joints. Do not use duct tape, screws or 

other fastening devices that extend into the interior of the vent 
to secure vent.

5. Clean exhaust vent periodically, depending on use, but at 

least every 2 years, or when installing your washer/dryer in a 
new location. When cleaning is complete, be sure to follow the 
Installation Instructions supplied with your washer/dryer for 
final product check.

For these suggested full-sized loads, set the LOAD SIZE selector to the highest load size setting.

2 pair of pants
3 pair of jeans
1 coverall
3 shirts

2 double sheets 
4 pillowcases
6 T-shirts
6 pair of shorts
2 shirts
2 blouses
6 handkerchiefs

  8 bath towels
  8 hand towels
10 washcloths
  1 bath mat

2 camisoles
4 slips
6 undergarments
2 sets of sleepwear
1 child’s outfit

1 double sheet
1 tablecloth
1 dress
1 blouse
2 pair of pants
3 shirts
2 pillowcases

2 pair of pants
2 blouses
4 shirts
4 tops
2 dresses