Brother FAX-T98 用户手册
MESSAGE MANAGER 8 - 16
Remote Control Commands
Follow the commands below to access features remotely. When you
call the fax machine and enter your Remote Access Code (3 digits
followed by
call the fax machine and enter your Remote Access Code (3 digits
followed by
), the system will signal you with two short beeps to
enter a remote control command.
Remote control commands
Detail Operation
91 Playing voice messages After one long beep, the machine plays ICM.
1 Skip back
Press 1 while listening to an ICM to play it again. If
you press 1 before a message, you will hear the
previous message.
you press 1 before a message, you will hear the
previous message.
2 Skip next
While playing ICM, you can skip to next message.
9 STOP Playing
Stop playing the ICM.
93 Erase all ICM
If you hear one long beep, the erase is accepted. If
you hear three short beeps, you cannot erase
because all voice messages have not been played,
or there is no voice message to erase.
you hear three short beeps, you cannot erase
because all voice messages have not been played,
or there is no voice message to erase.
*This code erases all recorded messages, not one
at a time.
at a time.
94 Play and Record OGM in
memory
1 Play
1 TAD MSG
The machine plays the selected OGM. You can
stop playing OGMs by pressing 9.
stop playing OGMs by pressing 9.
2 F/T MSG
3 PAGING MSG
2
Record
Record
1 TAD MSG
After one long beep, you can record the selected
OGM. You will hear the message played once. You
can stop recording the message by pressing 9.
OGM. You will hear the message played once. You
can stop recording the message by pressing 9.
2 F/T MSG
3 PAGING MSG