Bajaj Electricals HT65/MB165 用户手册

GREASING PROCEDURES TO THE DRIvING CHAIN

1.   Shut off the engine

2.   Add light amounts of machine oil or chain grease to the driving chain. (Too much machine 

oil or chain grease may cause splattering to occur.)

Attention:

The chain should be replaced when the adjusting limit has reached it’s maximum.

                   



ADJUSTMENT OF CHAIN

1.   When chain adjustment  is needed, loosen rear axle bolt .

2.   Turn the chain adjusting nuts on the left and right sides to adjust the tension of the chain 

and to align the marking of the chain adjuster with the engraved lines in the similar 

position on both sides.

3.   Tighten rear axle bolt  by a torque of 50-60Nm (37-44 ft.lb.).

4.   Repetitively check the tension of the chain.

15-20mm

1/2” - 3/4”

Chain adjusting nut

Both Sides 

Rear axle bolt