Baby Trend CS0190B0211 用户手册

child’s shoulders. (Fig. 30-1) The harness 

straps are adjusted as follows:

1.  Remove the Safety Seat from the Base and 

rotate the Carry Handle to the back position.  

Place your child in the Safety Seat such that 

your child’s bottom is all the way to the rear 

and bottom of the seat.   

2.  Determine which pair of slots will position the 

harness straps even with or just below your 

child’s shoulders.  

DO NOT use harness 

slots that will position the harness straps 

above your child’s shoulders as the harness 

straps in this position will not restrain a small 

child in a sharp turn, sudden stop or crash.

3.  If the Harness Straps require adjustment, 

remove your child from the Safety Seat.  

Rotate the handle to the upright carry 

position.  

4.  Loosen the harness straps by depressing 

the Harness Adjuster Button located below 

the flap just ahead of the Harness Buckle 

and pulling on the harness straps. 

5.  Turn the seat over.  Locate the Belt Adjuster 

Plate near the bottom of the seat.  (Fig. 30-2)  

Remove both Harness Straps from the Belt 

A

A

B

B

Fig. 30-1

Fig. 30-2

Proper height is even or 

just below shoulder

Adjuster Plate.  From the front of the seat, 

pull the Harness Straps through the shoulder 

area slots and seat pad.

6.  Using the included Belt Threading Tool, 

insert the Harness Straps through the Slots 

selected in step 2 above, in the seat pad and 

the seat shell, respectively.  (Fig. 31-1)

7.  From the rear of the Safety Seat, pull the 

Harness Straps through the Slots until you 

have enough strap to reach the Belt  

Adjuster Plate. 

8.  Reassemble the Harness Straps to the Belt 

Adjuster Plate.  Do the left Harness Strap 

first, followed by the right Harness Strap. 

Check that Harness Straps are completely 

within the Belt Adjuster Plate loop (Fig. 31-2).  

You have two adjustment positions on the 

harness. Use Position A for a smaller child, 

and Position B for a larger child. If using 

Position A, loop B must be on top of the Belt 

Adjuster Plate. (Fig. 31-3)

9.  Inspect the Harness Straps from the front 

and rear to ensure that they are not twisted.  

Twisted straps can prevent proper tightening 

of the Harness and thus may not adequately 

restrain your child in a sharp turn, sudden 

stop or crash.

A

A

B

Fig. 31-1

Fig. 31-2

Fig. 31-3

Belt Threading Tool

A

A

B

B