Brady 2461 用户手册

 

73

þ

 Note: The printhead is fragile; use extreme care when handling and never

use a sharp object on the surface. If you have any questions or
concerns regarding this procedure, contact a qualified technician or

Technical Support before proceeding.

If the printhead must be replaced, Locating Pins eliminate the need for printhead
alignment after the installation. To replace the printhead:

Œ

  Touch a bare metal part of the printer’s

frame to discharge any static electricity
that may be present.

• Turn ‘Off’ and unplug the printer. Open

the access cover, if ribbon is installed,
remove it.

Ž With the printhead locked in the down position, loosen the Printhead

Mounting Screw (it will remain captivated in the assembly).

• Rotate the printhead latch forward. While holding the Printhead, raise the

assembly. Disconnect the two Cables and then remove the old Printhead.

• While carefully

holding the new
Printhead, 

connect

both Cables.

‘ Position the Printhead

onto the Locating
Pins in the Printhead
Assembly and secure
in place with the
Printhead Mounting
Screw. (Do not over-
tighten this screw.)

’ Clean the Printhead; see Section 5.3.1.

“ Reload ribbon (if removed), lower the printhead assembly, and rotate the

printhead latch back, into the locked position. Plug in and turn ‘On’ the
printer. Print a Validation Label  from the Quick Test menu; see Section
4.3.5. If necessary, adjust the print darkness to match that of the previous
printhead using the Print Control/Custom Adjustments/Darkness setting in
the menu; see Section 4.1.3.