White Outdoor 1150W 用户手册

13

•

Drain the gasoline from the snow thrower, or place 
a piece of plastic film under the gas cap.

•

Tip the snow thrower up and forward so that it rests 
on its auger housing.

•

Remove the six self-tapping screws from the frame 
cover underneath the snow thrower.

•

Roll the front and rear auger belts off the auger 
drive pulley. See Figure 14.

•

Unhook the idler spring from the hex bolt on the 
auger housing. See Figure 14.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley.

NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.

•

Lift the rear auger belt from the auger pulley, and 
slip the belt between the support bracket and the 
auger pulley. Repeat this step for the front auger 
belt.

•

Replace both auger drive belts by following 
instructions in reverse order.

NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.

•

Follow the first four steps of the instructions for 
servicing the auger belts.

•

Pull the idler pulley up and lift the belt off the wheel 
drive pulley and friction wheel disc. See Figure 14.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley. See Figure 15.

•

Slip the belt between the friction wheel and drive 
disc. Remove and replace the belt. Reassemble 
following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.

The rubber on the friction wheel is subject to wear and 
should be checked after 25 hours of operation, and 
periodically thereafter. Replace the friction wheel 
rubber if any signs of wear or cracking are found.

•

Drain the gasoline from the snow thrower, or place 
a piece of plastic under the gas cap.

•

Tip the snow thrower up and forward, so that it rests 
on the housing.

•

Remove the six self-tapping screws from the frame 
cover underneath the snow thrower.

•

Remove the click pin that secures the left wheel to 
the axle and slide the wheel from the axle.

•

Remove the four screws securing the left drive 
cover to the frame. Remove the drive cover. See 
Figure 16.