Whirlpool LEQ8000HQ0 用户手册

T

ROUBLESHOOTING

C

OMMON DRYING PROBLEMS

• Lint screen is clogged with lint.

• Restricted air movement.

Exhaust vent or outside
exhaust hood is clogged with
lint.

• Exhaust vent is crushed or

kinked.

• One fuse is blown or circuit

breaker is tripped. The dryer
will appear to operate, but you
will not get any heat.

• Cycle Control knob or temper-

ature selector is set on air dry.

• Load not contacting the sensor

strips and automatic cycle 
ending early.

• Fabric softener sheets blocking

exhaust grill.

• Dryer located in room with 

temperature below 45ºF (7ºC).

• Large amount of moisture in

the load.

• Cold rinse water used.

• Load too large and bulky to

dry quickly.

• Power cord not firmly plugged

into a live circuit with proper
voltage.

• Fuses blown or circuit 

breakers tripped.

• Using a regular fuse.

• Dryer door not firmly closed.

• Start button not firmly pressed.

• Cycle Control knob set to Off.

• Clean lint screen.

• Run dryer for 5-10 minutes. Hold hand under 

outside exhaust hood to check air movement. If you
do not feel air moving, clean exhaust system of lint
or replace exhaust vent with heavy metal or flexible
metal vent (see your Installation Instructions).

• Replace with heavy metal or flexible metal vent

(see your Installation Instructions).

• Replace fuse or reset breaker.

• Select the right cycle and temperature for the types

of garments being dried (see “Using your Dryer”).

• Level dryer (see your Installation Instructions).

• Use only one softener sheet per load and only use

it once.

• Move dryer to a location with temperatures above

45ºF (7ºC).

• Expect longer dry times with items that hold more

moisture (cottons).

• Expect longer dry times.

• Separate load to tumble freely.

• Plug power cord into a live circuit.

• Replace fuses or reset breakers.

• Replace with a time-delay fuse.

• Close dryer door tightly.

• Press Start button again.

• Set knob to a cycle or time.