Whirlpool 3397627C 用户手册

If not reversing door swing, skip ahead to “Level and Exhaust the 

Dryer” steps.

Avoid scratching or chipping paint.

1.  Place a large towel or soft cloth (A) on top of dryer to avoid 

damaging the surface.

2.  Open dryer door. Remove bottom screws from cabinet 

side of hinges (B). Loosen (do not remove) top screws from 

cabinet side of hinges.

3.  Lift door until top screws in cabinet are in large part of hinge 

slot. Pull door forward off screws. Set door (handle side up) 

on top of dryer. Remove top screws from cabinet.

4.   Remove screws attaching hinges to door.
5.   Remove screws at top, bottom, and side of door. Holding 

door over towel on dryer, grasp sides of outer door and 

gently lift to separate it from inner door. Do NOT pry apart 

with putty knife. Do NOT pull on door seal or plastic door 

catches.

6.  Turn and reattach outer door panel to inner door panel so 

handle is on the side where hinges were just removed. Be 

sure to keep cardboard spacer centered between doors.

7.  Attach door hinge to door so large part of hinge slot is at 

bottom of hinge.

8.   Gently remove 4 hinge hole plugs (C) on left side of cabinet. 

Insert plugs in hinge holes on right side of cabinet.

9.  Insert screws in bottom holes on left side of cabinet. Tighten 

screws halfway. Position door so large end of door hinge 

slot is over screws. Slide door up so screws are in bottom 

of slots. Tighten screws. Insert and tighten top screws in 

hinges.

10.  Remove door strike (D) from cabinet. Remove door strike 

plug. Insert door strike in new hole and secure with screw. 

Insert door strike plug in original door strike hole and secure 

with screw.

11.  Close door and check that door strike aligns with door catch 

(E). If door does not close completely, slide door catch left or 

right within slot until strike snaps into catch.