Weslo WLEX1076.0 业主指南
5
ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included tools and your own adjustable wrench , Phillips screwdriver , and
pliers .
ing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the
included tools and your own adjustable wrench , Phillips screwdriver , and
pliers .
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled.
If a part is not in the hardware kit, check to see if it has been preassembled.
M4 x 25mm Round
Head Screw (41)–3
M8 Split
Washer (42)–7
M8 Nylon
Locknut (10)–4
M8 x 15mm Button
Screw (34)–3
M6 x 15mm Button
Screw (46)–4
M8 x 60mm Button
Screw (30)–4
M8 x 73mm Button
Screw (33)–2
1. Insert the Rear Stabilizer (6) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 60mm
Button Screws (30).
Button Screws (30).
6
30
1
2. Orient the Front Stabilizer (2) with the large holes
facing the Frame (1). Attach the Front Stabilizer to
the Frame with two M8 x 73mm Button Screws (33).
the Frame with two M8 x 73mm Button Screws (33).
1
1
2
33
2
Large
Holes
Holes