Weslo WLEMEL45000 业主指南

1. Hold one of the Stabilisers (68) against the saddle on

the front of the Base (1). Make sure that the Stabiliser

is turned so the square holes are facing away from the

saddle. Attach the Stabiliser with two M10 x 75mm

Carriage Bolts (66) and two M10 Nylon Locknuts (54).

Attach the other Stabiliser to the saddle on the back of

the Base (not shown).

2. While another person holds the Upright (2), gently

pull the Extension Wire (49) and the Resistance

Cable (33) up through the Upright until there is no

slack between the Upright and the Base (1).

Insert the four M10 x 68mm Bolts (67) up through the

Base (1). Slide the Upright (2) onto the Bolts. Be

careful to avoid pinching the Extension Wire (49)

and the Resistance Cable (33). Tighten an M10

Nylon Locknut (54) onto each Bolt.

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the

packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires a phillips screwdriver

, two adjustable wrenches

, and a

rubber mallet

3. Identify the Left Handlebar (6) and the Left Pedal Leg

(3) (there are stickers on the Handlebars and Pedal

Legs for identification).

Slide the Left Handlebar (6) onto the left Extension

Tube (5). Press the Handlebar Bushing (45) up into

the Left Handlebar. Align one of the three holes in the

Left Handlebar with the hole in the Extension Tube.

Insert the Left Lock Pin (37) into the holes, make sure

the Left Lock Pin is in the position shown in drawing

3a, and attach a Spring Clip (38) to the Left Lock Pin.

Attach a Pedal (29) to the Left Pedal Leg (3) with

three M4 x 16mm Screws (42).

Repeat this step to attach the Right Handlebar, right

Extension Tube, and Right Pedal Leg (not shown).