Wegener Communications DTV742 用户手册

800057-02 Rev. A

Page 3 of 11

May 24, 2003

Where X is the RF port number.
Press ENT to go to the third-level Input Setup Screens below and
use the 

5

 or 

6

keys to select <ON> or <OFF>, adding or

removing this program to/from the output stream. Press ENT
again to confirm.
Press the 

4

 key to go to the next RF Input screen (1 through 4).

Press the ESC key to return to the Input Setup screen.

Press the ENT key to toggle between ON and OFF, enabling or
disabling the tuner.
Press the 

4

 key to go to the Channel Number Selection screen.

Press the ESC key to return to the second-level RF Input screen.

Where XX is the current channel number.
Press ENT to enter the edit mode and use the 

5

 or 

6

keys to

change the channel number. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the 

4

 key to go to the RF Standard screen.

Press the 

3

 key to go to the Tuner Enable screen.

Press the ESC key to return to the second-level RF Input screen.

Press the ENT key to bring up the second-level Program
Input screen.
Press the 

4

 key to go to Program Status.

Press the 

3

 key to go to Clear Errored Seconds (if counter is

non-zero) or Alarms/Warnings.
Press the ESC key to go to the Home Screen.

Press ENT and use the 

5

 or 

6

keys to toggle the RF Standard

between Broadcast and Cable. Press ENT again to confirm your
selection or ESC to cancel changes.
Press the 

3

 key to go to the Channel Selection screen.

Press the ESC key to return to the second-level RF Input screen.