Brother FAX 580MC 业主指南
L O C A T I O N A N D C O N N E C T I O N S
2 - 9
Connections
The external TAD must be plugged into the back of the FAX/MFC, into the jack
labeled EXT. Your FAX/MFC cannot work properly if you plug the TAD into a wall
jack.
labeled EXT. Your FAX/MFC cannot work properly if you plug the TAD into a wall
jack.
1
Plug the telephone line cord from the wall jack into the back of the FAX/MFC, in the
jack labeled LINE.
jack labeled LINE.
2
Plug the telephone line cord from your TAD into the back of the FAX/MFC, in the
jack labeled EXT. (Make sure this cord is connected to the TAD at the TAD’s
telephone line jack (not to telephone set jack).)
jack labeled EXT. (Make sure this cord is connected to the TAD at the TAD’s
telephone line jack (not to telephone set jack).)
3
Set your external TAD to four rings or less. (The FAX/MFC’s Ring Delay setting does
not apply.)
not apply.)
4
Record the outgoing message (see below).
5
Set the TAD to answer calls.
6
See Message Storage (
Function/Set
,
8
,
1
) to VOICE:EXT.
7
Set the Answer Mode to MC:MSG CTR.
Outgoing Message (OGM)
Timing is important in recording this message. The message sets up the ways to handle
both manual and automatic fax reception.
both manual and automatic fax reception.
1
Record 5 seconds of silence at the beginning of your message. (This allows your FAX/
MFC time to listen for the fax CNG tones of automatic transmissions before they
stop.)
MFC time to listen for the fax CNG tones of automatic transmissions before they
stop.)
2
Limit your speaking to 20 seconds.
3
End your 20-second message by giving your Fax Receive Code for people sending
manual faxes. For example:
“After the beep, leave a message or send a fax by pressing
manual faxes. For example:
“After the beep, leave a message or send a fax by pressing
5 1 and Start.”
Connecting an External Telephone
Your FAX/MFC is equipped with a handset that you can use as a regular phone.
However, you can also connect a separate telephone (or telephone answering device)
directly to your FAX/MFC.
However, you can also connect a separate telephone (or telephone answering device)
directly to your FAX/MFC.
Connect the modular plug on the telephone’s line cord to the jack labeled EXT. on the
back of the FAX/MFC.
back of the FAX/MFC.
Whenever this phone (or TAD) is in use, the screen displays EXT. TEL IN USE, and,
if the FAX/MFC handset is lifted, an alarm sounds. To disconnect the call and switch
to the FAX/MFC, press
if the FAX/MFC handset is lifted, an alarm sounds. To disconnect the call and switch
to the FAX/MFC, press
Speaker Phone
.